Johnson Controls XP-910x Manual de usuario descargar pdf (Pagina 20)

20 Configuration Guides—XT-9100 Configuration Guide

The source of the digital output signal is defined in the DX-9100

Controller.

Via the GX Tool

Select XTn or (EXP), DOn, Data, and then the “Source Point” field. Enter

* and select the required source variable.

Via the SX Tool

Refer to the Extension Module Configuration section in the DX-9100

Configuration Guide (LIT-6364030).

1. When the XT-9100 is connected to a DX-9100 Controller, you can

view and override the DO value from the DX-9100 front panel. See

Display Panel and Keypads in the DX-9100 Extended Digital

Controller Technical Bulletin (LIT-6364020).

2. The digital output status can be seen at Item DOS1 (DI.07) for XP1

and Item DOS2 (DI.08) for XP2, bits X1-X8 for outputs DO 1-8 with

the SX Tool.

3. A configured DO is shown by a thick bar to the left and right of

its selection box.

Configure all DOs as ON/OFF or PULSE, whether they are used

or not. The only exception is for the 4-output relay module

(XP-9106). When only one XP-9106 module is installed, select

8DO, but only configure DO1-DO4. When two XP-9106 modules

are installed, configure both as one 8DO module, and configure

DO1-DO8.

DO Source

(with DX-9100

Only)

DO Notes

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Sin comentarios

Johnson Controls XP-910x Manual de usuario Pagina 20